Cleaning And Maintenance - STAMOS S-LS-97 Manual De Instrucciones

6. When you have finished using the unit, turn it off with the button (13),
remove the external load, and unplug the unit from the power source.
CAUTION! Switching on the unit with a previously connected consumer unit
to the output terminals is forbidden.
3.4.
a) Pull out the mains plug before each cleaning and when the unit is not in use.
b) Use only non-corrosive cleaning agents for cleaning the surfaces.
c) After each cleaning, all the parts should be dried well before the unit is used
again.
d) Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e) Do not spray the unit with a stream of water or immerse it in water.
f) Make sure that no water enters through the ventilation openings in the casing.
g) Clean the ventilation openings with a brush and compressed air.
h) Perform regular inspections of the unit checking technical fitness and any
damages.
i) To ensure fire protection, replace the fuse only with the specified type and
class.
Replacing the fuse
CAUTION! The fuse must be replaced by a specialist!
1. Disconnect the unit from the power supply.
2. Disconnect the power cord and remove the fuse holder.
3. Replace the fuse with a new one of the same rating.
4. Reinstall the fuse holder.
CAUTION! To avoid damaging the fuse holder, do not use excessive force when
removing and installing the fuse holder.
DISPOSAL OF USED UNITS.
At the end of its useful life, this product should not be disposed of with normal
household waste but should be taken to a collection point for the recycling of
electrical and electronic equipment. This is indicated by the symbol on the
product, operating instructions or packaging. The materials used in this unit are
recyclable according to their marking. You will be making an important
contribution to protecting our environment by reusing, recycling or otherwise
disposing of used units.

Cleaning and maintenance