Cleaning And Maintenance - STAMOS S-LS-104 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 82
7. Protection against overheating
If the protection is tripped, disconnect the unit from the power supply, cool it
down, and remove the cause of the protection trip.
The unit can be restarted.
8. When you have finished using the unit, turn it off with the button (13),
remove the external load, and unplug the unit from the power source.
CAUTION! Switching on the unit with a previously connected consumer unit
to the output terminals is forbidden.
Caution: Switching the unit on and off too often because of the
approximately 2-3 second delay between pressing the button and switching
it off completely is not recommended.
Maintain an interval of at least 10 seconds between switching the unit on
and off to avoid shortening its service life.
3.4.
a)
Pull out the mains plug before each cleaning and when the unit is not in use.
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
After each cleaning, all the parts should be dried well before the unit is used
again.
d)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e)
Do not spray the unit with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the casing.
g)
Clean the ventilation openings with a brush and compressed air.
h)
Perform regular inspections of the unit checking technical fitness and any
damages.
i)
To ensure fire protection, replace the fuse only with the specified type and
class.
Replacing the fuse
CAUTION! The fuse must be replaced by a specialist!
1. Disconnect the unit from the power supply.
2. Disconnect the power cord and remove the fuse holder.
3. Replace the fuse with a new one of the same rating.

Cleaning and maintenance

Publicidad

Tabla de contenido
loading

Tabla de contenido