Cleaning And Maintenance - STAMOS S-LS-88 Manual De Instrucciones

3.4. Cleaning and maintenance

a) Before cleaning and when the device is not in use, pull the power supply plug.
b) Use only non-corrosive agents for cleaning the surface.
c) After each cleaning, all components should be well dried before the device is
used again.
d) Store the device in a dry and cool place protected from moisture and direct
sunlight.
e) Do not spray the device with a stream of water and do not immerse it in water.
f) Ensure that no water enters through the ventilation openings in the housing.
g) Clean the ventilation openings with a brush and compressed air.
h) Regularly inspect the device for technical failure and damage.
i) Use a soft cloth for cleaning.
DISPOSAL OF USED DEVICES
At the end of its service life, this product must not be disposed of with normal
household waste, but should be taken to a collection point for the recycling of
electrical and electronic devices. This is shown by the symbol placed on the
product, operating manual or the packaging. The materials used in the device can
be reused according to their intended use. By reusing materials or conducting
other forms of using used devices, you make a significant contribution to the
protection of our environment.
Local administration will provide you with information about the appropriate
point for disposal of used devices.