universalblue UBE2408-21 Manual De Instrucciones página 42

to the gas or liquid gas mains must be carried out in accordance
with the regulation currently in force, and only after it has been
determined that it is adaptable to the type of gas to be used. If this
is not the case, follow the instructions given in the paragraph
"Adaptation to different types of gas".
In the case of connection for liquid gas, by tank, use pressure
regulators that comply with current regulations.
For safety, reasons, for the correct regulation of gas use
and to extend the life of the unit, make sure that the gas
pressure corresponds to the indications given in table 1
"Specification of burners and nozzles".
CONNECTION TO FLEXIBLE STEEL TUBE
The gas supply connector to the appliance is a 1/2 male connector
screwed into the round gas pipe. Only use pipes and seals that
comply with the standards currently in force.
The maximum length of the flexible pipes must not exceed 2,000
mm. Once the connection has been made, make sure that the
flexible metal pipe does not touch any moving parts and is not
crushed.
Check the Seal
Once the hob has been installed, make sure that all connections are
well sealed, using a solution of soapy water. Never use a flame.
ELECTRICAL CONNECTION
Gas hobs fitted with a tri-polar power supply cable are designed for
use with alternating current according to the indications on the type
42