universalblue UBE2408-21 Manual De Instrucciones página 43

label located under the appliance. The ground wire can be identified
by its yellow-green color.
In the case of installation on a recessed electric furnace, the
electrical connections of the unit and the oven must be independent,
not only for safety reasons, but also to facilitate the removal of one
or both in the future.
ELECTRICAL CONNECTION FOR THE GAS HOB
Connect the power cord to a standard plug with the rating indicated
on the rating label or plug it directly into the power supply. In the
latter case, a single pole switch must be fitted between the
appliance and the mains, with a minimum opening between the
contacts of 3 mm in compliance with current safety codes. The
power cable must be laid in such a way that it does not reach a
temperature of more than 50°C above the room temperature at any
point.
Before the actual connection, make sure of the following:
 That the fuse and electrical system can withstand the load
required by the hob.
 That the electrical supply system is equipped with an
efficient transmission on the ground circuit, according to the
rules and regulations prescribed by law.
 That the plug or switch is easily accessible.
The wires of the main cable are colored according to the
following code:
Green & Yellow
Blue
Brown
As the colors of the wires in the main outlet may not correspond
with the colored markings identifying the terminals in your plug,
Earth

Neutral

Live

43