Programming The Control Unit; Changing The Firing Program - Rohde ST 630 Operación Manual

6.5.

Programming the control unit

6.5.1.

Changing the firing program

Indicator
on the Main display
left
20 °C
PROG: 1
150°C/HR
632°C
Heating
zone display Meaning
on the right
No program
in operation
Program number
selection
Indicator in the
segment display
Heating ramp
Cooling ramp
Soak/Target
temperature
62 / 317 - EN -
Description
•
If no firing is carried out, no element lights
up in the program sequence of the
graphical display.
• The "Program running" indicator must not
light up
•
The main display shows the current firing
chamber temperature of the respective
heating zone.
g
•
When you press the
number lights up on the display.
•
The firing program can now be selected
d f
with the and keys.
g
• By pressing the key again, the program
number which is to be changed can be
selected.
•
You can switch back to the previous value
in each step by pressing the
The selected firing program always shows the
first segment first.
•
The ramp rate in the main display appears
as:
⇒ "0,1°C/h-9,9°C/h" or
⇒ "10°C/h-999°C/h" or
⇒ "FULL" or
⇒ "END"
•
This can be altered with the
•
The graphical display indicates whether a
heating ramp or a cooling ramp is being
programmed.
Notes:
⇒ To change the heating ramp to a cooling
ramp and vice versa, see Section
6.5.2./6.5.3.
⇒ To program the ramp rate to "FULL" or
"END", see Section 6.5.4./6.5.5.
⇒ To program the additional switch outputs
1 & 2 see section 7.4.
•
The next press of the
soak or target temperature.
• This can be altered with the
key, the program
h
key.
d f
& keys.
g
key displays the
d f
& keys.