Rohde ST 630 Operación Manual página 71

Programming an event:
Main display
Heating or cooling ramp
150°C/HR
Soak time
00 : 15
Switch outputs (event) indicator:
Switch output
Switch output
indicator
Event 1 ON
Event 2 ON
Event 1 & 2 ON
Event OFF
Note:
Before the program runs, the switch output (event) is inactive (relay contacts are open).
Switch output
Meaning
indicator
Heating ramp
Cooling ramp
Soak time
Description
The indicator LED for switch output 1 (event 1) lights up.
(Relay contacts are closed).
The indicator LED for switch output 2 (event 2) lights up.
(Relay contacts are closed).
The indicator LED for switch outputs 1 and 2 (events 1 and 2) lights up.
(Relay contacts are closed).
The indicator LEDs for switch outputs 1 and 2 do not light up.
Description
Event 1:
While programming a ramp, press the
g
the key to select event 1.
Event 2:
While programming a ramp, press the
h
the key to select event 2.
Event 1 & Event 2:
While programming a ramp, press the
g
the key to select event 1 and then press the
h
and then the
Event 1:
While programming a soak time, press the
g
then the key to select event 1.
Event 2:
While programming a soak time, press the
h
then the key to select event 2.
Event 1 & Event 2:
While programming a soak time, press the
g
then the key to select event 1 and then press the
key and then the
69 / 317 - EN -
<
<
<
key to select event 2.
h
key to select event 2.
key and then
key and then
key and then
<
key
<
key and
<
key and
<
key and
<