Program Delay; Display Description; Program Advance Facility; Program Pause Facility - Rohde ST 630 Operación Manual

8.1.3.

Program delay

The program delay or program time delay can be used to delay the start of the firing program to a specific point in time.
⇒ The program delay can be entered or changed immediately after the start of the respective program.
⇒ Immediately after pressing the
starts can be set with the
Display
00 : 00
⇒ The firing process can be started by pressing the
"Program running" indicator continues to signal that a firing is in progress.
Note:
The program delay for the delayed start for each firing process is set to "00.00" in the factory.
8.1.4.

Program advance facility

It is possible to jump to the next section of the firing program while the firing program is running.
• While firing press and hold down the
• The controller will emit a short beep and immediately advances the program by one step.
• The process is indicated accordingly in the course of the program on the graphical display by a flashing icon.
• The effect of this is as follows:
­
If ramping, then the controller will switch to soak at the current kiln temperature.
­
If soaking, then the controller will advance to the next segment if any, or else it will end the firing.
­
If the next segment is programmed with the end of the firing program "END", the current firing is ended.
• Changes made to the operation of the controller in this way are temporary and are not stored.
8.1.5.

Program pause facility

General safety note:
WARNING
Risk of serious damage to property due to too long a soak time when using the program
pause function.
⇒ If left too long at high temperatures, kiln damage could result.
⇒ The program pause function causes the program to pause but the temperature is still
⇒ Leaving the ware too long at high temperatures could damage it or have a negative
j
key, "00.00" appears in the main display. The waiting time before the firing
d f
and keys.
Description
While the firing indicator light is flashing on the display, a program start delay of up to
"99 hours:59 minutes" can be entered using the
<
key and the
maintained!
impact on the firing results.
71 / 317 - EN -
d
and
j
key again or will do so automatically after 5 seconds. The
d
key to obtain the program advance function.
f
keys.