Stihl KM 94 R Manual De Instrucciones página 15

position: After the engine has stopped,
the ignition is automatically switched on
again in the Run position – the engine is
ready for starting and can be started.
Function of the thumb wheel
4
The thumb wheel (4) is used to set the
throttle path infinitely between idling and
full throttle and therefore also the engine
speed range:
Turn thumbwheel (4) in – direction:
–
the throttle path is shorter and the
set maximum engine speed is lower
Turn thumbwheel (4) in + direction:
–
the throttle path is longer and the set
maximum engine speed is higher
Press the throttle trigger forcefully to
–
apply full throttle even if limitation
set– the set limitation is maintained–
when the throttle trigger is released,
it is back in the preset range.
KM 94 R
Starting the engine
5
Press the fuel pump bulb (5) at least
N
5 times - even when bulb is filled
with fuel
Turn thumb wheel as far as possible
N
in the direction+
Cold engine (cold start)
1.
6
2.
Turn the knob for start throttle (6)
N
and then press to g
Also use this setting if the engine has
been running but is still cold.
Hot engine (hot start)
The knob for start throttle (6)
N
remains in position F
Actuating
Place the machine on the ground so
N
that it rests securely on the engine
support:
(if present): Remove the transport
N
guard on the cutting attachment
The working tool must not touch the
ground or any other objects – see also
"Starting / stopping the engine" in the
KombiTool Instruction Manual – risk of
accident!
safe standing - possibilities:
N
standing, bent or kneeling
Press the machine firmly against
N
the ground with the left hand – do
not touch the throttle trigger, throttle
trigger lockout or stop switch while
doing so
NOTICE
Do not stand or kneel on the shaft!
English
13