Mafell Z5Ec Manual De Instrucciones página 23

Z5Ec
5.5.1 Working with the parallel guide fence
Use the following procedure to install the
parallel guide fence:
1. Loosen the two wing screws (5).
2. Insert the parallel guide fence (B) into the
guide provided for this purpose.
3. Tighten the two wing screws (5).
The parallel guide fence is installed.
✓
Use the following procedure to adjust the
cutting width:
1. Loosen the two wing screws (5).
2. Adjust the parallel guide fence (B).
3. Tighten the two wing screws (5).
The cutting width is adjusted.
✓
Alternatively, you can guide the machine with the parallel guide fence along a guide rail
or a wooden ledge fixed on the workpiece. This requires the parallel guide fence to be
rotated so that the guide tab points upwards.
02/2022
Fig. 21: Installing the parallel guide fence
Fig. 22: Adjusting the cutting width via the parallel guide
fence
23