Transport And Storage; Troubleshooting - Mafell Z5Ec Manual De Instrucciones

6.1 Transport and storage

Clean the machine thoroughly if you will not use it for quite some time. Spray bare metal parts with a rust
inhibitor.
7

Troubleshooting

Some of the most common malfunctions and their causes are listed below. For other malfunctions, please
contact your dealer or MAFELL Customer Service directly.
Malfunction
Machine can not be switched on
Machine stops during the cutting
process
Saw band jams when pushing
the machine forward
26
Danger!
Risk of injury due to improper transport or storage
Bystanders can be injured by the machine due to improper transport or storage.
For transport and storage, place the machine onto the base plate so that
➢
the cutting tool is exposed at the bottom. It is recommended to use the
Mafell transport cart for transport and storage (see Chapter 8, "Special
accessories").
Warning
Risk of injury from a sudden start of the machine.
There is a risk that the machine starts suddenly due to carelessness when
working with the machine or during troubleshooting. The rotating saw band can
cause serious injuries.
Determining the causes of existing malfunctions and their elimination
➢
always require increased attention and caution!
Pull out the mains plug before you start troubleshooting!
➢
Cause
Mains voltage missing or too low
Mains fuse defective
Mains failure
Power interruption
Saw band blunt
Elimination
Have the power supply checked
by an electrician
Have the fuse replaced by an
electrician
Have the mains back-up fuses
checked by an electrician
Switch the machine off and back
on
Release switch at once. Remove
the machine from the workpiece
and replace the saw band
Z5Ec
02/2022