Operation; Startup; Switching On; Rotational Speed Setting - Mafell Z5Ec Manual De Instrucciones

Z5Ec
5

Operation

5.1 Startup

These operating instructions must be brought to the attention of all persons entrusted with the operation of the
machine, with particular emphasis on the chapter "Safety instructions".

5.2 Switching on

Use the following procedure to switch on the
machine:
1. Push the blocking slider (3) upward to unlock.
2. Press the power switch (4) labeled "I".
The machine is switched on
✓

5.3 Rotational speed setting

Use the following procedure to select the
rotational speed:
1. Select the desired level at the setting wheel
(7).
➢ At the setting wheel (7), you can adjust
the saw blade speed continuously
between 650 and 1550 rpm.
The rotational speed is set.
✓
For solid wood, the rotational speed should be between stage 4 and 6. In general, full
rotational speed is recommended for all applications. Perform test cuts if necessary.
02/2022
Fig. 17: Switching the machine on
Fig. 18: Selecting the rotational speed at the setting wheel
21