Maintenance; Clean & Lube Mandrel; Lubricate Rotating Parts - Stanley PNT1000L-PC Manual De Instrucciones

Maintenance

Table 9: Maintenance Schedule
Item
Lubricate Air
Clean & Lube Mandrel
Inspect Nosepiece

Lubricate rotating parts.

Inspect Control Nut, T Valve Push Rod.
Recharge hydraulics
Clean & Lube Mandrel
• Clean and Lube the Mandrel every 50 sets.
• Over time, debris can stick to the Mandrel reducing its lubrication making it diffi cult to mount POP NUTs™ or
causing premature wear or jams.
• Lube the Mandrel with 1 drop of oil. Use the same oil that is used with the Air Lubricator or an ISO VG 32 type oil.
Lubricate Rotating Parts
• Lubricate the Spin Pull Head and Spin Pull Head Case after approximately every 1000 sets.
• Lack of lubrication will cause increase internal friction causing premature wear and reducing the Mandrel rotation
speed and torque
Frequency
1-2 drops/20 sets
50 sets
50 sets
1000 sets
Mandrel breakage
Loss of Stroke
Figure 15: Clean and Lube Mandrel
Spin Pull Head Case
Spin Pull Head
Figure 16: Lubricating the Spin Pull Head
Details
• See "Tool Setup"
• Lubricates internal seals and Air Motor
• Replace if worn/damaged
• Prevents insert damage or jamming.
• Replace if worn/damaged
• Prevents insert damage or jamming.
• Prevents loss of Mandrel rotation force.
• Replace if bent or broken
• See "Recharging Hydraulics"
E N G L I S H
23