Maintenance; Regular Maintenance; Major Maintenance - Stanley EZM4000 Manual De Instrucciones Y Servicio

E N G L I S H

5. MAINTENANCE

Use safety goggles
Use hearing protection
Use safety gloves

5.1 REGULAR MAINTENANCE

Turn off the closing valve (F) and disconnect the air supply (G).
- Dismantle anvil(see fig 6.1.a). then Clean using an air blow
gun and soft cloth.
- Dismantle the mandrel (see fig 6.1.b) Clean using an air blow
gun and soft cloth.
- Clean front sleeve (see fig. 6.1.c) using an air blow gun and
soft cloth.
- Lubricate mandrel after reassembly.

5.2 MAJOR MAINTENANCE

Every 100.000 cycles tool must be completely dismantled and all
seals and worn parts must be replaced. This must be done only by a
trained engineer or listed service center.
12
O R I G I N A L I N S T R U C T I O N
F
G
fig. 6.1.a
fig. 6.1.b
fig. 6.1.c