Attaching The Fan Blades; Installing The Mounting Plate - Kichler Lucian II Manual De Instrucciones

ATTACHING THE FAN BLADES

CAUTION: To Reduce The Risk Of Electric Shock, Disconnect The
Electrical Supply Circuit To The Fan Before Installing Fan Blades.
CAUTION: Remove the five rubber shipping blocks attached to the face
of the motor. These blocks keep the motor from shifting during shipping
and MUST be removed during installation.
Step 1. Attach a blade to a blade bracket using the screws and fiber
washers provided. (Fig. 14)
Make sure the blade is straight when set on the blade bracket. Tighten
each mounting screw until the fiber washer is slightly compressed. Repeat
this procedure for each blade.
Step 2. Attach each blade assembly to the motor using the blade bracket
mounting screws. (Fig 14)

INSTALLING THE MOUNTING PLATE

Step 1. Loosen the two screws on the mounting ring attached to the motor
shaft and "remove" and save the third screw. (Fig. 15)
Step 2. Place the key holes on the mounting plate over the 2 screws
previously loosened from the mounting ring, turn mounting plate until it
locks in place at the narrow section of the key holes. Secure by tightening
the 2 screws previously loosened and the one previously removed. (Fig. 15)
12 | KICHLER.COM
Screws
Fiber Washers
Blades
Screws
Blade
Brackets
Fig. 14
Mounting Plate
Fig. 15
Mounting
Ring
Screws