3. SLIGHT AIR CONDITIONER NOISE
- A low hissing noise may be heard when the compressor is running, or has just been switched off.
It is the noise of the refrigerant running or stopping.
- A low "squeaking" noise may also be heard when the compressor is running, or has just been switched
off. This is caused by expansion due to the heat or contraction due to cold of the plastic parts of the unit,
when the temperature changes.
- A noise may be heard due to the louvre restoring itself to its original position on commissioning.
4. DUST IS BLOWN OUT FROM THE INDOOR UNIT.
- This is normal when the air conditioner is re-started after a long period of inactivity, or is used for the first
time.
5. A STRANGE ODOUR IS DETECTED COMING FROM THE INDOOR UNIT.
- It is caused by the indoor unit, which releases the odours absorbed by the construction materials, the
furnishings or from smoking.
6. THE AIR CONDITIONER GOES TO FAN ONLY MODE FROM HEATING AND COOLING MODE
- When the indoor temperature reaches the temperature set on the air conditioner, the compressor stops
automatically and the air conditioner goes to fan only mode. The compressor will start again, when the
indoor temperature increases in cooling mode, or lowers in heating mode.
7. POSSIBLE DRIPPING OF WATER.
- Droplets of water may form on the surface of the indoor unit when cooling is activated in high relative
humidity conditions (relative humidity above 80%).
Adjust the horizontal louvre to maximum opening to allow the air to escape and select high fan speed.
8. HEATING MODE
- The air conditioner takes heat from the outdoor unit and releases it through the indoor unit during operation
in heating mode. When the outdoor temperature lowers, the heat introduced by the air conditioner
consequently decreases.
- Simultaneously, the air conditioner heat production load increases due to the greater difference between
the indoor and outdoor temperatures.
- If a comfortable temperature cannot be obtained only with the air conditioner, it is recommended to use
an additional heating device.
9. AUTOMATIC RE-START FUNCTION
- The indoor unit has an automatic re-start button (auto-reset). Whenever there is unexpected power failure,
the settings present at the time of the voltage drop will be restored. The unit will automatically re-activate
the previous operational settings after 3 minutes from the voltage being restored.
10. LIGHTENING OR ELECTRIC EQUIPMENT
- Lightening or wireless phones working in the vicinity could cause the air conditioner to malfunction.
6 - ACCESSORIES
An incorrect installation may cause water leakage, electric shocks and fire, or cause a mal-
function of the equipment.
Name of
Accessories
Manual
Installation plate (some
models)
EN - 12
Q'ty
Shape
(pc)
2~4
1
Name of
Accessories
Plastic expansion sheath
(depend-
(some models)
models)
Self-Tapping Screw A
(depend-
(some models)
models)
Q'ty
Shape
(pc)
5-8
ing on
5-8
ing on