Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Positioning
Install this appliance at a location where the ambient temperature corresponds to the
climate class indicated on the rating plate of the appliance:
Location
The appliance should be installed well away from sources of heat such as radiators,
boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the
cabinet. To ensure best performance, if the appliance is positioned below an overhan-
ging wall unit, the minimum distance between the top of the cabinet and the wall unit
must be at least 100 mm. Ideally, however, the appliance should not be positioned
below overhanging wall units. Accurate leveling is ensured by one or more adjustable
feet at the base of the cabinet.
Warning! It must be possible to disconnect the appliance from the mains power supply;
therefore be easily accessible after installation.
Electrical connection
Before plugging in, ensure that the voltage and frequency shown on the rating plate
correspond to your domestic power supply. The appliance must be earthed. The power
supply cable plug is provided with a contact for this purpose. If the domestic power
supply socket is not earthed, connect the appliance to a separate earth in compliance
with current regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above safety precautions are not
observed.
This appliance complies with the E.E.C. Directives.
Climate class
SN
N
ST
T
Ambient temperature
o
o
+10
C to +32
C
o
o
+16
C to +32
C
o
o
+16
C to +38
C
o
o
+16
C to +43
C
57
Publicidad
Tabla de contenido
