Connecting External Device - inbody 970 Manual De Usuario

E. Connecting Compatible Device
To connect an compatible device to InBody970, check the communication method of the compatible device. There are two
ways of communication; wired connection such as USB or RS232C (9-pin serial terminal, Female), and wireless connection
(Bluetooth).
1. Wired connection
1) Printer
The Result Sheet can be printed if the printer is connected to InBody970.
* Please visit the following website to find out the compatible printers for InBody970 : https://www.inbodyservice.com
Turn off InBody970.
❶
* When InBody970 is already turned on, the printer might not properly connect.
Connect the USB cable supplied with the printer to the USB HOST printer terminal on the rear of InBody970.
❷
Connect the other end of the USB cable to the USB connection terminal of the printer.
Turn on the printer.
❸
Connect the printer according to the instructions on "09. Printer Setup" in Setup in Administrator Menu.
❹
You can set the options related printing from "10.Results Sheet Types" to "15.Printing Alignment" in Setup in
❺
Administrator Menu.
2) Stadiometer
The height values measured by the stadiometer are sent to InBody970 when it is connected to InBody970.
* Please make sure to connect only BSM Stadiometer series provided by InBody.
Turn off InBody970.
❶
* When InBody970 is already turned on, the stadiometer might not properly connect.
Connect the serial cable supplied with the stadiometer to the Stadiometer 9-pin serial terminal on the rear of
❷
InBody970. Connect the other end of the cable to the serial terminal of the stadiometer.
Turn on the stadiometer.
❸
Turn on InBody970. When the stadiometer is connected, (
❹
standby screen.
USB HOST
Printer Port
Stadiometer 9-pin
Serial Terminal
) icon will be displayed in the upper left of the test
EN
13