Inserting And Removing The Battery - brennenstuhl MULTI HL 3000 Manual De Instrucciones

MULTI HL 3000
Model:
Compatible battery types:
Max. projected area:
Dimensions:
Dimensions of protective cover: 11.1x11.1x2 cm
Weight:
This product is suitable for indoor and outdoor lighting purposes.
COMMISSIONING
Place the spotlight on a dry, flat surface or take the spotlight in your hand.
With the adjustable foot bracket, different angles of inclination of the spotlight can be
realised (Fig. 2a). The foot bracket is also equipped with magnets.
To switch on the spotlight, press the switch at the top of the handle.
Pressing it once activates the spotlight with full light intensity. Pressing it again
(within five seconds) switches the spotlight to the secondary light source (100%) (Fig. 2b).
This can be adjusted to 75%, 50% and 25% by pressing again and then switched off (Fig. 2c).
The less light output is set, the longer the light duration.
If a switch position remains unchanged for more than 5 seconds, pressing it again always
leads to the "off" state.
If the battery is almost empty, the LED spotlight flashes five times. After that, the spotlight
will continue to shine at 50% brightness for approx. 10 minutes, depending on the battery
capacity, before the deep discharge protection switches the spotlight off.
This leaves enough time to change the battery or to finish the work.

INSERTING AND REMOVING THE BATTERY

The floodlight is intended for operation with the subsequently listed batteries:
brennenstuhl® professionalLINE battery AB 1805
Bosch battery GBA 18 V x.x Ah Professional
Bosch ProCORE 18 V (up to a max. of 12 Ah) Professional
Dewalt 18 Volt rechargeable batteries
Festool 18 Volt rechargeable batteries
Flex 18 Volt rechargeable batteries
Makita 18 Volt rechargeable batteries
Metabo (CAS) 18 Volt rechargeable batteries
Milwaukee 18 Volt rechargeable batteries
The adapter can be inserted quickly and easily.
To do this, open the catch and pull the battery cover towards you (Fig. 1a - 1b). Now insert
the matching adapter into the Brennenstuhl interface (Fig. 1c) and lock it with the red
locking mechanism (Fig. 1d). Insert the charged 18 volt battery into the battery holder
from behind (Fig. 1e) until you feel it click into the end position.
To remove the battery, press the battery release button and pull the battery back out of
the battery holder.
Then close the cover again (Fig. 1f ).
013122 BA_MULTI HL 3000 0533947.indd 9 013122 BA_MULTI HL 3000 0533947.indd 9
MULTI HL 3000
Bosch Professional batteries 18 V/2-12 Ah
Dewalt, Festool, Flex, Makita, Metabo (CAS),
Milwaukee (18 V rechargeable batteries)
183.63 cm
2
18.2x13.8x21.4 cm
1.37 kg
Operating instructions
9
26.04.22 12:53 26.04.22 12:53