Top/Bottom Installation Configuration - Olimpia splendid UNICO R Instrucciones Para El Uso Y El Mantenimiento

To replace the power cord, proceed as follows:
a. Remove the lower cover (interlocking)
(A) (fig. 25).
b. Remove the upper cover (interlocking)
(B) (fig. 25).
c.
Unscrew the 6 screws that lock the
front cover (fig. 26).
d. Remove the front cover (C) (fig. 27)
and remove the cover of the electrical
box (D) (fig. 27).
e. Unscrew the cable clamp (E) (fig. 27)
and unscrew the cable locking screws
of the terminal block (F) (fig. 27).
f. Remove the present cable and insert
the new cable following the same path.
g. Remove the wooden wedge on the
back of the machine.
h.
Lock the three poles of the cable in the
terminal block and tighten the screws
(F) (fig. 27).
i. Secure the cable with the clamp (E)
(fig. 27).
l. Close the board protection (D) (fig. 27).
m. Refit the front cover of the machine with the six screws.
n.
Reassemble the two interlocking covers (upper and lower).
27

2.5 - TOP/BOTTOM INSTALLATION CONFIGURATION

The unit can be installed both in the lower part (adjacent to the floor) and in the upper
part (adjacent to the ceiling) of the wall.
EN - 22
F
C
25
B
26
E
D
A