Publicidad
support@nextlevelracing.com
PEDAL PLATE ANGLE ADJUSTMENT
32
Uninstall the front Bolts, Square Washers and Flange Nuts securing the Pedal Angle Plate to the Pedal Frame and loosen the rear
Bolts. Adjust to the desired angle. Bolt through and secure with the Bolts, Square Washers and Flange Nuts previously uninstalled.
HOTAS POLE HEIGHT ADJUSTMENT
33
Loosen the Knobs securing the HOTAS Inner Pole to the HOTAS Outer Pole. Adjust to desired height
and tighten Knobs to lock in place.
HOTAS POLE ANGLE ADJUSTMENT
34
Uninstall the front Bolts, Washers and Flange Nuts securing the HOTAS Plate to the HOTAS Inner Pole. Angle to
the desired position. Bolt through and secure with 1 x Bolt, Washer and Flange Nut previously uninstalled.
20
PARTS:
CENTRE POLE HEIGHT ADJUSTMENT
• • NIL
35
PARTS:
CENTRE PLATE ANGLE ADJUSTMENT
• • NIL
36
PARTS:
TPR RUDDER INSTALLATION
• • NIL
37
Loosen the Knobs securing the Inner Centre Pole to the Outer Centre Pole. Adjust the Inner Centre Pole to the
desired height and tighten the Knobs to secure in place. Utilize the multiple threaded inserts for a perfect fit.
Uninstall the front Bolts, Washers and Flange Nuts securing the Centre Plate to the Inner Centre Pole. Angle to
the desired position. Bolt through and secure with 1 x Bolt, Washer and Flange Nut previously uninstalled.
Install 4 x M6 Threaded Studs into the TPR Adaptor.
21
Video Instruction: bit.ly/nlrbuild
PARTS:
• • NIL
PARTS:
• • NIL
PARTS:
• • 1 x TPR Adaptor
• • 4 x M6 20mm Threaded Studs
Publicidad
