Publicidad
support@nextlevelracing.com
OPTIONAL HOTAS INSTALL
13
Align the mounting holes on the HOTAS Outer Pole with the through holes on the Cross Member.
Bolt through and secure with 2 x M8 Bolts, Washers and Flange Nuts.
)
)
A
B
14
Align the threaded inserts on the HOTAS Inner Pole with the slot on the HOTAS Outer pole.
Bolt through and secure with 2 x Knobs.
15
Align the mounting holes on the HOTAS Plate with the through holes on the HOTAS Inner Pole.
Bolt through and secure with 3 x M8 Bolts, Washers and Flange Nuts.
12
PARTS:
)
• • 1 x HOTAS Outer Pole
A
• • 2 x M8 55mm Bolts
• • 2 x M8 Washers
• • 2 x M8 Flange Nuts
16
PARTS:
• • 1 x HOTAS Inner Pole
• • 2 x 20mm Knobs
17a
PARTS:
• • 1 x HOTAS Plate
• • 3 x M8 55mm Bolts
• • 3 x M8 16mm Washers
• • 3 x M8 Flange Nuts
17c
)
B
A) Align the mounting holes on the Centre Outer Pole with the holes on the Pedal Frame.
B) Align the Barrel Spacer with the holes on the Centre Outer Pole. Bolt through and secure with 2 x M8 Bolts, Washers and
Flange Nuts.
17b
Gently place the Center Pole on top of the Pedal
Frame and make sure the latch is down.
17d
Make sure the U bolt is sitting properly in the
locking tab and pull the latch until its tight.
13
Video Instruction: bit.ly/nlrbuild
PARTS:
• • 1 x Centre Outer Pole
• • 2 x M8 55mm Bolts
• • 2 x M8 Washers
• • 2 x M8 Flange Nuts
• • 1 x Barrel Spacer
Hook the U-Bolt into the locking tab on the Pedal
Frame.
For a tighter lock, undo the latch, adjust the nuts
at the top of the latch and close it back again.
Publicidad
