Publicidad
support@nextlevelracing.com
)
B
Repeat
)
A
on Other
Side
A) Apply pressure to the seat base with body-weight. Pull up the recliner handle with one hand and adjust so that the recliner is perpendicular
07
with the Seat Bottom. Repeat on other side (It is recommended to use a cloth/cardboard in palm to prevent injury to hands).
B) Uninstall 4 x Dome Head Bolts which are pre-installed on the Seat Backrest and align the threaded inserts on the Seat Backrest with the
mounting holes on the Seat Bottom.
C) Bolt through and secure with 4 x M8 Dome Head Bolts which were previously uninstalled. Remove the warning labels on the recliners.
)
)
)
A
B
C
(4x Seat Mounting Locations)
(Two Each Side of Seat Frames)
08
A) Pull the Seat Slider handle up and adjust the Seat to the forward-most position.
B) Align the mounting holes on the Seat Sliders with the seat mounting locations (Refer to image) on the Left and Right Seat Frames.
C) At the rear, bolt through and secure with 2 x M8 Square Neck Bolts and Flange Nuts.
)
)
A
B
09
A) Pull the Seat Slider handle and adjust the Seat to the rear-most position.
B) At the front, bolt through and secure with 2 x M8 Square Neck Bolts and Flange Nuts.
10
PARTS:
)
C
• • 1 x Seat Backrest
• • 1 x Seat Bottom
PARTS:
• • 2 x M8 16mm Square Neck Bolts
• • 2 x M8 Flange Nuts
PARTS:
• • 2 x M8 16mm Square Neck Bolts
• • 2 x M8 Flange Nuts
)
)
A
B
A) Align the mounting slots on the Left and Right Side Arms with the through holes on the Left and Right Seat Frames
10
and Side Panels.
B) Bolt through and secure with 4 x M8 Bolts, Washers and Flange Nuts.
SIDE ARM ADJUSTMENT
11
Loosen the Bolts to adjust the Side Arms to the desired height and angle. Tighten the Bolts to lock in
place. Utilize the extra through holes on the Seat Frames for back and forward adjustment.
NOTE: The plates are
interchangeable and
can be mounted to
accommodate for left or
right-handed users.
12
Align the Threaded Studs on the Mouse Plate and Flight Plate with the mounting holes on the Left and
Right Side Arms. Secure with 8 x M8 Flange Nuts.
Video Instruction: bit.ly/nlrbuild
PARTS:
L)
R)
• • 2 x Side Arms
• • 4 x M8 55mm Bolts
• • 4 x M8 Washers
• • 4 x M8 Flange Nuts
PARTS:
• • NIL
PARTS:
• • 1 x Mouse Plate
• • 1 x Flight Plate
• • 8 x M8 Flange Nuts
11
Publicidad
