Publicidad
support@nextlevelracing.com
NOTE: If high end yokes are being
used, please install the optional
Support Bracket (Step 23 - 26).
18
Install 1 x Felt Pad onto the top of the Centre Inner Pole. Align the threaded inserts on the Centre Inner
Pole with the slots on the Centre Outer Pole. Bolt through and secure with 2 x Knobs.
CENTRE YOKE PLATE INSTALL
19a
Align the mounting holes on the Centre Yoke Plate with the through holes on the Centre Inner Pole.
Bolt through and secure with 3 x M8 55mm Bolts, Washers and Flange Nuts.
OPTIONAL TURTLE BEACH
ADAPTOR INSTALL
(Continue from Step 19a)
19b
A) Insert the 2 x M6 Studs into the rear-most holes on the Centre Yoke Plate.
B) Align the mounting holes on the Turtle Beach Adaptor Plate with the threaded studs, secure with 2 x M6 Flange Nuts.
PARTS:
• • 1 x Centre Inner Pole
• • 2 x 20mm Knobs
• • 1 x Felt Pad
PARTS:
• • 1 x Centre Yoke Plate
• • 3 x M8 55mm Bolts
• • 3 x M8 16mm Washers
• • 3 x M8 Flange Nuts
PARTS:
• • 1 x Turtle Beach Adaptor Plate
• • 2 x M6 20mm Press Fit Studs
• • 2 x M6 Flange Nuts
14
BOEING YOKE/CLAMP PLATE INSTALL
B
)
A
)
C
A) Place the Clamp Plate on top of the Centre Inner Pole.
19c
B) Slide the Clamp Plate forward and align the mounting holes on the Centre Inner Pole and Clamp Plate.
C) Bolt through and secure with 2 x M8 Bolts, Washers and Flange Nuts.
CENTRE KEYBOARD PLATE INSTALL
19d
Align the mounting holes and slots on the Keyboard Plate with the through holes on the Centre Inner
Pole. Bolt through and secure with 2 x M8 Bolts, Washers and Flange Nuts.
Video Instruction: bit.ly/nlrbuild
PARTS:
)
• • 1 x Clamp Plate
• • 2 x M8 55mm Bolts
• • 2 x M8 Washers
• • 2 x M8 Flange Nuts
PARTS:
• • 1 x Keyboard Plate
• • 2 x M8 55mm Bolts
• • 2 x M8 Washers
• • 2 x M8 Flange Nuts
15
Publicidad
