Publicidad
support@nextlevelracing.com
Thread the Seatbelt through the eyelets in the Seat Backrest. Align the mounting holes on each Seatbelt
20
mounting plate with the through holes on the Seat Frames and the threaded inserts on the underside of the Seat
Bottom. Bolt through and secure with 4 x M8 Bolts, Washers and 2 x M8 Flange Nuts.
21
Align the Adjustable Feet with the threaded inserts on the bottom of the Pedal Frame and Seat Frames. Lock into
place by twisting the Adjustable feet into the threaded inserts. To raise an Adjustable Foot, twist anti-clockwise.
22
Your Flight Simulator cockpit is complete.
PARTS:
• • 1 x Seatbelt
• • 2 x M8 20mm Bolts
• • 2 x M8 55mm Bolts
• • 4 x M8 Washers
• • 2 x M8 Flange Nuts
PARTS:
• • 6 x Adjustable Feet
PARTS:
• • NIL
16
OPTIONAL SUPPORT BRACKET INSTALL
23
Align the pivot point on the Support Bracket with the mounting holes on the Support Bracket Mount.
Bolt through and secure with 1 x M8 Bolt, Washer, Barrel Spacer and Flange Nut.
)
)
A
B
24
A) Uninstall the Knobs securing the Centre Inner Pole to the Centre Outer Pole and remove the Centre Outer Pole.
B) Uninstall the 2 x M8 Flange Nuts securing the HOTAS Outer Pole to the Cross Member.
25
Align the mounting holes on the Support Bracket with the through holes on the Cross Member.
Secure with 2 x M8 Flange Nuts previously uninstalled in Step 24.
Video Instruction: bit.ly/nlrbuild
PARTS:
• • 1 x Support Bracket
• • 1 x Support Bracket Mount
• • 1 x M8 70mm Bolt
• • 1 x Barrel Spacer
• • 1 x M8 Washer
• • 1 x M8 Flange Nut
PARTS:
• • NIL
PARTS:
• • 2 x M8 Flange Nuts
17
Publicidad
