STERWINS A061003 Manual De Instrucciones página 264

1. SAFETY INSTRUCTIONS
of the machine.
For rotary tillers, ensure that only replacement cutting systems of
the right type are used.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
Replace worn or damaged parts for safety. Use only genuine
replacement parts and accessories.
When servicing the blades be aware that, even though the power
source is switched off, the blades can still be moved.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
The extension cable, plug and socket must be watertight and
intended for outdoor use.
Always allow the machine to cool down before storing.
When you want to store the tool:
- Loose the quick release lock system on handles
- Fold the handles as shown in the illustration Store it.
The machine should be supplied via a residual current device (RCD)
with a tripping current of not more than 30 mA.
Make sure that air circulation is adequate and good. The product
must be easily accessible from all sides.
During transportation of the product, the operator must control
the handles by two hands.
Caution: An inadequate extension cable can be dangerous and can
cause accidents. Please contact a qualified electrician for advice if in
any doubt.Replace worn or damaged parts for safety.
261
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN