Setup And Assembly - Orbitalum RPG ONE Traducción Del Manual De Instrucciones Original

RPG ONE, RPG 1.5, RPG 2.5
8.

SETUP AND ASSEMBLY

DANGER!
WARNING!
WARNING!
WARNING!
WARNING!
[REV. 20190314] OC_RPG_S_BA_790036765_00__INH-02_EN
Machine start-up due to unintentional pressing of the ON/OFF switch or the
speed regulator!
Fatal electric shock.
Diverse physical injuries and material damage.
X At the end of each working cycle, before transportation, changing tools, cleaning and
performing any maintenance, adjustment or repair work, switch off the machine, wait
until the machine/tool stops running and pull the mains plug and/or take the recharge-
able battery out of the machine.
Protruding tool holder!
Hands may be crushed and the machine damaged.
X The tool holder with fitted MFW must not project over the edge of the tool support.
X Before switching on the machine, make sure that the distance between the MFW and
the housing is sufficient.
X Close the viewing window before switching on the machine.
Risk of machine and tube falling!
Irreversible crushing.
X Check the machine's position and secure it so it cannot fall.
X Ensure that the machine has a solid footing (see chap. 6.4, p. 59).
X Place sufficient supports under the tube.
Fingers jammed between the clamping unit, clamping shells and tube!
Irreversible crushing.
X Do not place fingers between the clamping unit, clamping shells and tube.
X At the end of each working cycle, before transportation, changing tools, cleaning and
performing any maintenance, adjustment or repair work, switch off the machine, wait
until the machine/tool stops running and pull the mains plug and/or take the recharge-
able battery out of the machine.
X Always close the viewing window after removing chips.
Flying parts/breaking tool!
Diverse physical injuries and material damage.
X No damaged or deformed cutting tools (MFW) should be used.
X Firmly clamp the tube to be machined into the clamping unit.
X Immediately replace worn-out tools.
X Ensure that the cutting tools are correctly fitted.
X The inner diameter of the clamping shells must be identical to the outer diameter of the
tube to be machined. The specific inner diameter is specified on the clamping shells. The
outer diameter of the tube must be determined.
X Avoid tool breakage by ensuring low (measured) infeed (max. clamping thickness: 0.05
mm) and correct setting of speed (see chap. 9.2, p. 72).
X Check that the tool holder (WH) and multifunctional tool (MFW) are seated firmly, and
tighten if required.
Setup and assembly
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
ENGLISH
61