Orbitalum RPG ONE Traducción Del Manual De Instrucciones Original página 67

RPG ONE, RPG 1.5, RPG 2.5
3. Press on the clamping shell slightly and install it into the
adapter clamping shell.
NOTE! The Orbitalum logo on the clamping
shell must correspond with the clamp
screw (3) (see arrows).
4. Tighten the clamping shell with the tensioning screw
(large handle) (3).
The clamping shell has now been installed correctly.
NOTE!
ATTENTION!
[REV. 20190314] OC_RPG_S_BA_790036765_00__INH-02_EN
The clamping shell has been correctly installed, if it is locked in place. If the clamp shell is not
locked, this can be rectified by a gentle turn of the clamping shell.
Using the adapter clamping shell could lead to collisions with the tool!
Damage to tool.
X Take care that there is enough space between the tool and the adapter clamping shell.
Setup and assembly
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
ENGLISH
3
67