Inserting/Replacing The Clamping Shells; Inserting A Clamping Shell - Orbitalum RPG ONE Traducción Del Manual De Instrucciones Original

ENGLISH
Setup and assembly
8.3

Inserting/replacing the clamping shells

8.3.1

Inserting a clamping shell

1. Press a little on the clamping shell and install it in the body.
RPG 1.5, RPG 2.5 (cordless): The Orbitalum logo on the clamping shell
must correspond with the clamp screw (see arrows).
NOTE! The clamp shell has been installed correctly, if it is locked
in place. If the clamping shell is not locked, this fact can be
rectified by a gentle turn of the clamping shell.
2. Setting up clamping shells:
RPG ONE (cordless): Tighten the clamping shell with the tensioning screw (1).
RPG 1.5 (cordless), RPG 2.5 (cordless): Tighten the clamping shell with the clamping screw (2).
1
RPG ONE (Cordless)
The clamping shell has now been set up correctly.
64
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
2
RPG 1.5 (Cordless)
RPG ONE, RPG 1.5, RPG 2.5
2
RPG 2.5 (Cordless)
[REV. 20190314] OC_RPG_S_BA_790036765_00__INH-02_EN