Clamping The Tube - Orbitalum RPG ONE Traducción Del Manual De Instrucciones Original

ENGLISH
Setup and assembly
8.5

clamping the tube

WARNING!
NOTE!
1. Set up the tube in the clamping shell of RPG or with the use of a RPG Cordless, guide the machine to the tube and pick it up
with the clamping shell.
2. To clamp the tube, rotate the tensioning screw (large handle) (1) in a clockwise direction until the stop.
3. Check that the tube is correctly seated.
The tube can be processed now.
X To release the tube from the machine, rotate the tensioning screw (large handle) (1) in an anti-clockwise direction until the stop.
68
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
Flying parts/breaking tool!
Diverse physical injuries and material damage.
X No damaged or deformed cutting tools (MFW) should be used.
X Firmly clamp the tube to be machined into the clamping unit.
X Immediately replace worn-out tools.
X Ensure that the cutting tools are correctly fitted.
X The inner diameter of the clamping shells must be identical to the outer diameter of the
tube to be machined. The specific inner diameter is specified on the clamping shells. The
outer diameter of the tube must be determined.
X Avoid tool breakage by ensuring low (measured) infeed (max. clamping thickness: 0.05
mm) and correct setting of speed (see chap. 9.2, p. 72).
X Check that the tool holder (WH) and multifunctional tool (MFW) are seated firmly, and
tighten if required.
Clamp the tube squarely, ensuring that the tube and machine axes are aligned. If care is not
taken, the tube end may not be processed at right angles.
1
[REV. 20190314] OC_RPG_S_BA_790036765_00__INH-02_EN
RPG ONE, RPG 1.5, RPG 2.5