Orbitalum RPG ONE Traducción Del Manual De Instrucciones Original página 70

ENGLISH
Operation
WARNING!
ATTENTION!
ATTENTION!
ATTENTION!
70
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
Flying, hot and sharp­edged chips, tube surfaces, cutting edges and tools!
Danger of injury to eyes and hands.
X Do not touch the rotating tool while the machine is in operation.
X Never work without attached viewing window covering the work area.
X Wear recommended protective clothing, as described in chap. 2.4, p. 46.
X At the end of each working cycle Maschine ausschalten, switch off the machine, wait un-
til the machine/tool stops running and pull the mains plug and/or take the rechargeable
battery out of the machine. Remove chips with tightfitting safety gloves (in accordance
with DIN EN 388 and EN 407) using suitable tools (e.g. tongs or screwdriver).
X Ensure that the viewing window is functional.
Restarting the machine following blockage!
Diverse physical injuries and material damage.
X In the event of a blockage, always disconnect the machine from the power supply before
clearing it.
X If necessary, remove any tensioned parts before restarting the machine.
A tube that is not sawn off at right-angles can damage the tool (MFW) if
the distance between the cutting edge and the tube end is too small!
Damage to tool.
X Before switching on the machine ensure that the tool has sufficient axial distance around
the complete tube circumference.
X Only drive the rotating tool with limited feed to the tube.
X General trouble shooting, see chap. 10.2, p. 78.
RPG Cordless:
Excessive feed during the operation, and the ON/OFF switch still remains
depressed, the operation may be damaged (by overheating)!
X Release the ON/OFF switch immediately and separate the machine from the tube.
If the speed is reduced too quickly whilst operating, the tool may "dig in",
causing damage to the face and the tool, and may cause the machine to stop!
X Always reduce the feed gradually.
RPG ONE, RPG 1.5, RPG 2.5
[REV. 20190314] OC_RPG_S_BA_790036765_00__INH-02_EN