SOLAC CE4480 Instrucciones De Uso página 11

ANOMALIES
If you detect any anomalies, refer to the following table:
Anomaly Possible cause
Water flows -The filterholder is not fitted
out of the side correctly.
of the holder - The Edge of the sieve is
covered coffee.
-The brewing group is dirty.
No coffee - There is no water
comes out - The water tank is not prop-
erly placed.
- The filter holes are clogged,
the coffee is ground too fine
or has been pressed too
much
The coffee -The coffee grinding is too
comes out fine or too pressed
slowly or drop
by drop
The coffee -The used Coffee is out of
comes without date
cream -The Coffee has not been
pressed enough.
-The Ground coffee is too
coarse.
The coffee -The ground coffee is too
comes out too coarse.
fast -There is not enough coffee in
the sieve.
-The Coffee has not been
pressed enough
No steam -The Tube is clogged
escapes from
the evapora-
tor tube
Solutions
-See Section "filling coffee"
-Clean the sieve around the edge and clean
the brewing of coffee group
-Clean With a damp cloth.
- Fill the water tank
- Make sure the tank is properly seated,
pressing on the top
-Empty the filter basket and clean with water.
Clean the brewing unit with a damp cloth. Fill
the sieve again and press the coffee slightly
-Make sure grinding is OK and it's not too
pressed.
-Use Fresh coffee and once opened store in
an airtight container.
-Press slightly the coffee.
-Grind finer the coffee
-Grind coffee finer
-Ensure that it's the right amount of coffee in
the sieve.
- Press slightly the coffee
Clean the steam tube with a damp cloth to
remove any traces of milk have dried and
unblock holes using a needle. Press the
corresponding switch and remove steam until
it goes out continuously
EN