Operating Informations; Brush Assembly / Disassembly - Lavorwash QUICK 36E Manual

In the event of changes to the equipment, i.e. the type
of battery and charger, we always recommend that
you contact your authorised service centre both for
the machine setting and the setting of the charger's
charging curve.
As a general rule, the following criteria apply:
For Pb-acid and GEL batteries: charging current of ap-
prox. 10-12% of the capacity in Ah-C20
For lithium batteries: charging current of approx. 40%
of the capacity in Ah
Failure to comply may result in serious damage to
the battery and warranty invalidation.
6.3.

BRUSH ASSEMBLY / DISASSEMBLY

• Never use the machine if the brush or the pad
holder with abrasive pad is not perfectly installed.
Assembly:
Place the brush on the floor;
lift the squeegee using the lifting/lowering lever (
Photo 2 - B )
Holding the handlebar ( Photo 1 - A ) push it down-
ward in order to lift the front part of the machine by
rotating it on the rear wheels;
move the machine and place it over the brush, taking
care that the coupling flange on the brush is under
the metal coupling of the machine ( Photo 20 ).
Switch on the machine using the key switch ( Photo
8 - A ) or the general ON/OFF switch on the control
panel ( Photo 5 - A ).
Select the brush rotation with the brush switch (
Photo 5 - D ; Photo 7 - C ) and start the brush rotation
pulling the control lever ( Photo 2 - A ): the brush will
couple automatically.
To assemble the pad holder follow the same procedure.
• Do not allow the length of the rows of brushes to
become lower than 1 cm.
• Do not allow the thickness of the abrasive disks to
become less than 1 cm.
Working with excessively worn brushes or excessively
thin abrasive disks may damage the machine and the
floor.
Regularly check the wear on these parts before start-
ing to work.

6. OPERATING INFORMATIONS

Disassembly or replacement:
Lift the squeegee using the lifting/lowering lever (
Photo 2 - B )
Holding the handlebar ( Photo 1 - A ) push it down-
ward in order to lift the front part of the machine by
rotating it on the rear wheels;
Select the brush rotation with the brush switch ( Photo
5 - D ; Photo 7 - C ) and start the brush rotation pull-
ing the control lever ( Photo 2 - A ) while holding the
machine lifted up; release the control lever to stop the
rotation: the brush will unhook automatically.
To disassemble the pad holder follow the same pro-
cedure.
40
Photo 20
Photo 21