Squeegee Blades Disassembly / Assembly; Filling And Draining The Solution Tank; Draining The Recovery Tank - Lavorwash QUICK 36E Manual

6.7. SQUEEGEE BLADES DISASSEMBLY /
ASSEMBLY
Disassemble the squeegee from its support ( see 7.5).
Unscrew the knobs ( Photo 24 - A ) and remove metal
blade retainer ( Photo 24 - B )
Extract the fixing bolts ( Photo 24 - C ) and remove the
front metal blade retainer ( Photo 25 - A );
remove the squeegee rubber blades tearing them from
a side.
To replace the squeegee rubber blades, follow the same
procedure on the contrary starting from the front blade;
lock the fixing bolts ( Photo 24 - C ) retaining them in
the squared seats in the squeegee body;
then, place the rear rubber blade ( Photo 24 - D ) and
the metal blade retainer ( Photo 24 - B ), locking them
with the fixing knobs ( Photo 24 - A ).
6.8. FILLING AND DRAINING THE SOLUTION
TANK
☞ The temperature of the water or the detergent
should never exceed 50°C.
☞ Always empty the recovery tank ( Photo 1 - B ) be-
fore filling the solution tank ( Photo 1 - D )
To fill the tank:
- Pour into the tank the required quantity of the
chemical product, considering the percentage indi-
cated by the supplier, with reference to the full tank
capacity listed on the product sheet.
• Use only those products suitable for the floor and
the dirt to be removed.
- Pour water in the filling opening placed in the front
of the machine ( Photo 28 - A ).
Leave 2 cm between the filling opening and the liquid
level. Do not fill beyond this point!
• The machine have been designed for the use
A
Photo 28
A) Solution tank filling opening
6. OPERATING INFORMATIONS
with non-foaming and biodegradable detergents
made specifically for scrubber-driers. The use
of other chemical products (such as sodium hy-
pochlorite, oxidizers, solvents or hydrocarbons)
may damage or destroy the machine.
- Follow the safety regulations specified in the relative
A) Water filter cap for the drainage of the
solution tank
section and indicated on the detergent container.
- Contact the machine manufacturer to obtain a com-
plete list of available and suitable detergents.
☞ Always use non-foaming and biodegradable
detergents
- Do not leave the water hose unattended and insert
it completely into the tank: the hose might move and
get sensitive parts of the machine wet.
Close the tank with its foam plug.
To drain the tank:
- Unscrew the cap of the water filter placed in lower
part of the solution tank and wait untul the tank is
completely empty ( Photo 29 - A ).
- Screw the water filter cap firmly.
6.9.
The dirty water must be drained in accordance with
national regulations.
The user is completely responsible for ensuring com-
pliance with such rules.
After the detergent solution is finished, always empty
the recovery tank ( Photo O - 3) before filling it again.
In general, the recovery tank can be emptied when-
ever required, and even during intermediate phases
of the work cycle.
The recovery tank and solution tank volume are the
same and to avoid situations of potential danger for
the suction motor it is necessary to
43
Photo 29

DRAINING THE RECOVERY TANK

A