Stanley SST1801 Manual De Instrucciones página 37

Fitting the table saw to the stand (see FIG. C1, C2)
There are four mounting holes on the base of the saw. 4
corresponding mounting holes are located on the top plane of
the stand. Put the table saw on the stand, match the holes on
the base of the saw with the holes on the stand, and secure
them with the 4 bolts (12) provided. DO fully fasten
12
C1
12
C2
Transportation (Fig C3)
Pull out the right side extension as the temporary handle to
transport the table saw on its wheels."
C3
Handle assembly (Fig D)
Place washer (e), housing (b), washer (c) and hex nut (d) on
the bolt (a) to assemble the handle (11)
D
Riving knife set-up (Fig E, F, G)
WARNING! Disconnect the mains cable! The
setup of the riving knife (3) must be checked
before each use.
1. Set the saw blade (4) to the max. cutting depth, put it at 00
position and lock it
2. Remove the table insert (20) (Fig. E)
4 20
E
WARNING! For transport reasons, the riving
knife (3) was fixed in the lower position before
initial commissioning. Only work with the
machine if the riving knife (3) is in the upper
position. Fitting the riving knife (3) in the upper
position is as follows:
3. Loosen the locking handle (f) and push the riving knife (3)
in the upper position (Fig.F)
ENGLISH
d
c
b
e
a
11
37