Stanley SST1801 Manual De Instrucciones página 41

Bevel cuts (Fig R)
Bevel cuts must always be made using the rip fence (5).
- Set the blade (4) to the desired angle.
- Proceed as for cross cutting
21a 6
R
Cutting particle boards
To prevent the cutting edges from cracking when working with
particle boards, the saw blade must be higher than the
workpiece height.
Auxiliary tools stored (Fig S,T)
Auxiliary tools can be stored on the machine Miter gauge (6)
could be put on hook as Fig S showed. Blade guard (2) and
push stick (19) could be put on hook as Fig T showed.
S
T
4 21b
6
2
19
Blade jamming handling (Fig U)
- Ensure the machine is disconnected from the power
source.
- Remove the wookpiece at first. Warning: Be careful of
your hands not toughing the saw blade.
- Press the overloaded protector (22) and connect the plug
again, the machine can be resumed to work. (Fig. U)
U
Applications
1. Make sure the kerf is made on the scrap side of the
measuring line.
2. Cut the wood with the finished side up.
3. Always have a proper support for the wood as it comes
out of the blade.
4. Make a test cut for important cuts.
5. Always use the correct blade depth setting. The top of the
blade teeth should clear the top of the material being cut
by 1⁄8" (3 mm) to 1⁄4" (6 mm).
6. Inspect the work-piece for knots or nails before beginning
a cut. Remove any loose knots with a hammer.
7. Always use clean, sharp, properly-set blades. Never make
a cut with a dull blade.
8. When making a cut, use steady, even pressure. Never
force a cut.
9. DO NOT cut wet or warped lumber.
10. Always hold your work-piece firmly with both hands or use
a push stick.
MAINTENANCE
Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance. Keep tools sharp and
clean for better and safer performane. Inspect tool cords
periodically and if damaged, have repaired by an authorized
service facility. Your power tool requires no additional
lubrication or maintenance. There are no user serviceable
parts in your power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free of dust. If you see
some sparks flashing in the ventilation slots, this is normal and
will not damage your power tool. If the supply cord is damaged,
it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
ENGLISH
22
41