Risk Of Electric Shock; Description Of The Device - Kärcher WD 1s Classic Manual De Instrucciones

Risk of electric shock

DANGER
● Only connect the device to alter-
nating current. The voltage indicated on the type plate
must match the voltage of the power source. ● Never
touch the mains plug and socket with wet hands. ● Only
operate the device via a fault current protection switch
(maximum 30 mA). ● Do not immerse the device in wa-
ter.
WARNING
● Only connect the device to an
electrical connection which has been set up by a quali-
fied electrician as per IEC 60364-1. ● Check the power
supply cable with mains plug for damage before opera-
tion each time. Do not put the device into operation with
a damaged power supply cable. Have a damaged pow-
er supply cable replaced immediately by the authorised
customer service / qualified electrician. ● Do not dam-
age the power supply and extension cable by running
over it, crushing or yanking it or similar. Protect the pow-
er supply cable from heat, oil and sharp edges.
CAUTION
● In case of longer breaks in opera-
tion and after use, switch off the device at the main
switch / device switch and pull the mains plug. ● Switch
off the device and unplug the mains plug before per-
forming cleaning/maintenance. ● When using the de-
vice, pull the power supply cable fully out of the device.
If the cable is wrapped around the cable hook, you must
undo it completely. ● Do not carry/transport the device
using the power supply cable. ● Do not pull the mains
plug out the socket using the power supply cable.
Wet vacuum cleaning
WARNING
● In case of any foam formation or escaping liquids,
switch off the device immediately and remove the
mains plug.
Operation
DANGER
● Operation in explosive atmospheres is prohibited.
● Risk of explosion
● Never use the device to vacuum up combustible
gases, liquids or dusts.
● Never use the device to vacuum up reactive metal
dusts (e.g. aluminium, magnesium, zinc).
● Never use the device to vacuum up undiluted brine
or acids.
● Never use the device to vacuum up any burning or
smouldering objects/matter.
These substances can corrode the materials in use
on the device.
WARNING
● Risk of injury. Do not use the nozzle and suction pipe
at head height.
CAUTION
● Never leave the device unsupervised while it is in op-
eration.
● Accidents or damage due to the device falling over.
Before all actions with or on the device, you must
make sure that it is stable.
ATTENTION
● Protect the device from extreme weather conditions,
moisture and heat.
● Never use the device without a filter, this can lead to
device damage.
10
WARNING
● Switch off the device immediately and remove the
mains plug before performing any care and service
work.
CAUTION
● Have repair work and work on electrical components
carried out by the authorised customer service only.
ATTENTION
● Do not use scouring agents, glass or multi-purpose
cleaner for cleaning.
CAUTION
● In order to prevent accidents or injuries, you must ob-
serve the weight of the device when transporting it.

Description of the device

Depending on the model selected, there are differences
in the equipment. The specific equipment is described
on the device packaging.
For the illustrations, refer to the graphics page.
Illustration A
Steering roller
1
Suction connection
2
Suction head
3
ON/OFF switch
4
Carry handle
5
Accessories storage
6
Container closure
7
Container
8
Cable hooks
9
Mains connection with mains plug
10
Blowing connection
11
Suction hose
12
Suction pipes
13
Crevice nozzle
14
Floor nozzle for dry and wet vacuum cleaning
15
Main floor nozzle for dry vacuum cleaning
16
Foam filter (only for wet vacuum cleaning)
17
Non-woven filter bag (only for dry vacuum cleaning)
18
Filter bag (only for dry vacuum cleaning)
19
Installing the steering rollers
1. Install the steering rollers before initial startup.
Illustration B
Illustration C
Illustration D
Illustration E
English
Care and service
Transport