Etac Molift Air 200 Manual De Instrucciones página 11

Ocultar thumbs Ver también para Molift Air 200:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 90
Transfer
Plan the lifting operation in advance to ensure that it is as safe
and smooth as possible. Remember to work ergonomically. Assess
the risks and take notes. The carer is responsible for the safety of
the user.
Molift Air can be used with both 2-point and 4-point sling bar for
different types of transfers; sitting, recumbent or ambulating.
Using slings
It is important that the sling has been tested with the individual
user and for the intended lifting situation.
Read User Manual for the sling prior to use.
Do not to use damaged or badly worn slings.
Slings made by other manufacturers
We recommend only using Etac or Molift slings. Etac shall not
be liable for faults or accidents that can occur when using slings
made by other manufacturers.
Lifting and lowering
When moving the user, stand to the side of the user you are lift-
ing. Make sure that arms and legs do not obstruct the seat, bed,
etc. Keep eye contact with the user to help them feel safe.
The 4-point sling bar must always be positioned across the user,
to prevent the user from unintentionally sliding out of the sling.
The sling bars hook design prevents sling to be inadvertently
detached when mounted correct.
Molift Air 200/350 | BM16199 Rev K | www.etac.com
1.
Check that the sling is correctly fitted around the user and
that the strap loops are correctly fitted to the sling bar
hooks.
2.
Stretch the sling straps without lifting the user. Ensure that
all four loops of the sling are securely fastened to avoid the
user slipping or falling.
3.
Lift user, and perform transfer.
Do not use the emergency stop to turn OFF
the hoist, except in an emergency.
The hoist will switch OFF (stand by) automati-
cally after 5 minutes of inactivity.
Angle sensor
The hoist has a directional safety feature that prevents lifting if
angle on lifting strap is to steep.
>30˚
If the hoist doesn't respond to Hand control "up" button, it
might be because lifting strap angle is to steep, or lifting belt is
twisted and sensor is activated.
8

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Molift air 350

Tabla de contenido