Getting Started/Installation - Emos E6016 Manual

precipitation sensor measurement range: 0 to 2,999 mm
unit of precipitation: mm/inch
radio signal range: to 100 m in open area
number of sensors which can be connected: max. 3 (temperature/humidity/wind sensor), max. 1
(precipitation sensor)
wireless sensor: transmission frequency 433 MHz, 10 mW e.r.p. max.
station power supply: 3× 1.5 V AAA batteries (not included)
adapter AC 230 V/DC 5 V, 300 mA (included)
temperature/humidity/wind sensor power supply: 4× 1.5 V AA (not included)
precipitation sensor power supply: 2× 1.5 V AA (not included)
station dimensions and weight: 17 × 192 × 127 mm, 364 g
temperature/humidity/wind sensor dimensions and weight: 275 × 135 × 310 mm, 377 g (without
batteries)
precipitation sensor dimensions and weight: 100 × 106 × 166 mm, 220 g (without batteries)

Getting Started/Installation

1. Plug the power adapter into the station, then insert batteries first into the weather station and then
into: wireless temperature/humidity/wind sensor and wireless precipitation sensor. The battery
compartment of the precipitation sensor is protected by screws; use a suitable screwdriver.
2. When inserting the batteries make sure the polarity is correct to avoid damaging the weather
station or sensors. Only use alkaline batteries of the same type; do not use rechargeable batteries.
3. Place all the units next to each other. The weather station will automatically detect the signal
from sensors within 3 minutes. If signal from sensors is not detected, long-press the
on the weather station to repeat the search and press the TX button on the sensor.
4. To ensure correct measurement, the temperature/humidity/wind sensor and precipitation sensor
must be placed above the ground surface (at least 1.5 m) onto a horizontal surface and outside
of buildings and structures. Both sensors must be firmly screwed on to prevent their damag-
ing. First, screw the mounting plate onto a level surface, then mount the mounting rod into it.
Screw the temperature/humidity/wind sensor onto the rod. Wind must flow freely around the
wind sensor from all sides. Check that the wind direction indicator and paddles for measuring
wind speed can rotate freely. The north arrow (N) on the built-in compass must point to the real
north. The south indicator (S) must point south in reality. Otherwise, wind direction will always
be displayed incorrectly. When choosing a suitable place for mounting the sensor, check before
installation that the main station is within range of the sensors. The range of the sensors may
decrease substantially in areas with large number of obstacles.
5. Do not place the sensors onto metal objects as this will reduce their transmission range.
6. If the low battery icon is displayed, replace batteries in the sensors or weather station.
Changing Channel and Connecting Additional Sensors (Valid for Temperature/
Humidity/Precipitation Sensor)
1. Choose the desired channel 1, 2, or 3 for the sensor by repeatedly pressing the
long press the button; the
2. Remove the cover from the battery compartment on the rear of the sensor and set the sensor
switch to the desired sensor channel number (1, 2, 3), then insert batteries (4× 1.5 V AA). Data
from the sensor will be loaded within 3 minutes.
3. If sensor signal is not found, remove the batteries and proceed again in accordance with steps
1 and 2 or press the TX button.
Attention:
The anemometer (wind speed and direction measurement) only functions on channel 1 (spare
sensor E06016).
Channels 2 and 3 are used for information about outdoor temperature and humidity (spare sensor
E06018).
icon will start flashing.
5
button
button. Then,