Setting Time - Emos E8636 Manual De Instrucciones

Displaying Data from Multiple Sensors, Automatic Cycling
through Values from Connected Sensors
Press the button repeatedly to display data from all connected
sensors on the thermometer, one by one. You can also activate
automatic cycling through data from all connected sensors:
1. Turning on cycling
Repeatedly press the
Data from all connected sensors will be shown automatically and
repeatedly one after another.
2. Turning off cycling
Press the button; the

Setting Time

1. Long press the
2. Use the arrow
3. Use the button to navigate between the values.
4. Hold the up or down arrow to adjust values faster.
Setting 12/24 Hour Time Format
Repeatedly pressing the
time format.
Switching °C/°F Units of Temperature
Repeatedly pressing the down
and °F units.
Setting an Alarm
Long-press the
Navigate between the values using the
Once the hours and minutes are set, press the
The alarm icon
To deactivate the alarm, press the
disappear.
To return to standard time display, wait 20 seconds or press
Snooze and Display Backlight Functions
Press the SNZ/LIGHT button when the alarm is ringing to postpone
the alarm by 5 minutes.
cancel the snooze function, press any button other than SNZ/LIGHT.
button until the display shows the
icon will disappear.
button on the back of the thermometer.
/ buttons to set hours and minutes.
button switches between 12/24 h
button and use
on the screen indicates the alarm is active.
icon will be flashing on the screen. To
7
arrow switches between °C
/ to set alarm time.
button.
button again.
button again. The icon will
icon.
.