Safety Instructions For Miter Saws - Bosch GCM18V-10SD Instrucciones De Funcionamiento Y Seguridad

5. Battery tool use and care
a. Recharge only with the charger specified
by the manufacturer. A charger that is suit-
able for one type of battery pack may create
a risk of fire when used with another battery
pack.
b. Use power tools only with specifically
designated battery packs. Use of any other
battery packs may create a risk of injury and
fire.
c. When battery pack is not in use, keep it
away from other metal objects like paper
clips, coins, keys, nails, screws, or other
small metal objects that can make a con-
nection from one terminal to another.
Shorting the battery terminals together may
cause burns or a fire.
d. Under abusive conditions, liquid may be
ejected from the battery, avoid contact.
If contact accidentally occurs, flush with
water. If liquid contacts eyes, additionally
seek medical help. Liquid ejected from the
battery may cause irritation or burns.
e. Do not use a battery pack or tool that is
damaged or modified. Damaged or modified
batteries may exhibit unpredictable behav-
a. Miter saws are intended to cut wood or
wood-like products, they cannot be used
with abrasive cut-off wheels for cutting
ferrous material such as bars, rods, studs,
etc. Abrasive dust causes moving parts
such as the lower guard to jam. Sparks from
abrasive cutting will burn the lower guard,
the kerf insert and other plastic parts.
b. Use clamps to support the workpiece
whenever possible. If supporting the work-
piece by hand, you must always keep your
hand at least 100 mm (4") from either side
of the saw blade. Do not use this saw to
cut pieces that are too small to be securely
clamped or held by hand. If your hand is
placed too close to the saw blade, there
is an increased risk of injury from blade
contact.
c. The workpiece must be stationary and
clamped or held against both the fence
16099221PJ GCM18V-10SD OSI 20220506.indd 5
General Power Tool Safety Warnings

Safety Instructions for Miter Saws

iour resulting in fire, explosion or risk of
injury.
f. Do not expose a battery pack or tool to
fire or excessive temperature. Exposure to
fire or temperature above 265 °F may cause
explosion.
g. Follow all charging instructions and do not
charge the battery pack or tool outside
the temperature range specified in the
instructions. Charging improperly or at
temperatures outside the specified range
may damage the battery and increase the
risk of fire.
6. Service
a. Have your power tool serviced by a
qualified repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
b. Never service damaged battery packs.
Service of battery packs should only be per-
formed by the manufacturer or authorized
service providers.
and the table. Do not feed the workpiece
into the blade or cut "freehand" in any
way. Unrestrained or moving workpieces
could be thrown at high speeds, causing
injury.
d. Push the saw through the workpiece. Do
not pull the saw through the workpiece.
To make a cut, raise the saw head and pull
it out over the workpiece without cutting,
start the motor, press the saw head down
and push the saw through the workpiece.
Cutting on the pull stroke is likely to cause
the saw blade to climb on top of the work-
piece and violently throw the blade assem-
bly towards the operator.
e. Never cross your hand over the intended
line of cutting either in front or behind the
saw blade. Supporting the workpiece "cross
handed" i.e. holding the workpiece to the
-5-
5/6/22 11:42 AM