45° Bevel Stop - Bosch GCM18V-10SD Instrucciones De Funcionamiento Y Seguridad

Fig. 22
7
8
12
Fig. 23
Fig. 24
Lock nut
Bevel stop
bolt
33
16099221PJ GCM18V-10SD OSI 20220506.indd 26
Adjustments
45° Bevel Stop
Checking 45° Bevel Stop Setting
1. Hold the saw head assembly (Fig. 22, 28)
28
down and push in the head assembly lock
pin (8) to keep the saw in the DOWN posi-
tion.
2. Slide the saw head assembly (28) complete-
ly to the back and tighten the slide rail lock
knob (7).
22
3. Rotate the table to the 0° miter position.
4. Rotate the bevel lock knob (Fig. 20, 34)
clockwise to unlock the head assembly.
5. Move the left sliding fence (Fig. 22, 12) fully
to the left.
6. Check the position of the bevel stop indica-
tor (Fig. 24, 33). It should be at the "45°"
position.
0° Bevel
7. Tilt the saw head assembly (Fig. 22, 28) to
Adjustment
the left (counterclockwise) until it hits the
Screw
45° stop. This is where the saw's 45° stop is
set to make a 45° left bevel cut.
8. Use a combination square to check that the
blade is 45° to the table. Remove the rule
blade from the combination square
25). Place only the combination square's
head on the saw's table with its long flat side
resting on the table and its 45° side against
the tilted blade (25).
Fig. 25
Combination
-26-
25
Square's
45° side
square
(Fig.
5/6/22 11:42 AM