Attaching The Base Extensions; Inserting And Releasing Battery; Pack - Bosch GCM18V-10SD Instrucciones De Funcionamiento Y Seguridad

Attaching the Base Extensions

Attach each base extension to the left and right
side of the base:
1. Place the base extension (Fig. 9, 16) flush
against the base.
Fig. 9
16
Torx screws
2. Using the Torx wrench (Fig. 7, 41) and the
Torx screws provided (Fig. 9 and Fig. 10),
attach the base extension (16) to the base.
3. Using the Torx wrench (Fig. 7, 41), tighten
Fig. 10
both Torx screws until the base extension is
fully seated against the base (Fig. 10). Then
16 tighten both Torx screws another 1/8 turn.
NOTE: To avoid overtightening and damaging
the threads of the Torx screws, tighten the Torx
screws by hand with the Torx wrench (41). Do
not use a power screwdriver or impact wrench
on the Torx screws.
16099221PJ GCM18V-10SD OSI 20220506.indd 19
Assembly
Inserting and Releasing Battery Pack
Slide charged battery pack (Fig. 11, 44) into the
battery bay (39) until the battery pack locks into
position.
Your tool is equipped with a secondary locking
latch to prevent the battery pack from com-
pletely falling out of the battery bay, should it
become loose due to vibration.
To remove the battery pack, press the battery
pack release button (38) and slide the battery
pack completely out of the battery bay.
Fig. 11
Torx screws
-19-
38
44
39
5/6/22 11:42 AM