Tubing Care; Condensation; Overflow - Medela Pump In Style Advanced Manual De Instrucciones

Tubing Care
Inspect tubing after each pumping session for condensation and/or milk. It
is not necessary to clean tubing after every use.
Condensation Appears in Tubing:
To eliminate condensation after you have completed pumping, continue
running the pump with the tubing(s) attached for another 1-2 minutes
or until dry.

Overflow:

Milk in tubing:
1. Turn off the pump and unplug from power source.
2. Remove and disassemble the tubing. Wash in soapy water, then
rinse in cold clear water.
3. Attach tubings to pump and run pump 2 minutes or until dry, or
pour a small amount of isopropyl alcohol through the tubings to dry.
(Tubing can be cleaned using a Quick Clean Micro-Steam bag. Make
sure tubing is fully immersed in water inside of bag).
Milk accidentally gets behind the Diaphragm Cap:
1. Turn off the pump and unplug from power source.
2. Remove and disassemble the tubing.
3. Snap off the diaphragm cap using
thumb tab.
4. Be sure the yellow plug is not plugged
into any ports prior to cleaning. Wash the
diaphragm cap in soapy water, then rinse
in cold, clear water.
5. Use a damp (not wet) cloth to wipe the diaphragm and bag. Do not
immerse the motor unit or any of the bags in water.
6. When components are completely dry, reassemble breastpump
and kit.
6