Lavorwash SWL R 1000 ET Manual De Instrucciones página 30

COLLECTION BIN:
The container or collection bin Part. 1 Fig. 7, made of resistant plastic, holds all the material picked up by the
central brush and the filter dust. It can be easily removed thanks to a wheeled frame Part. 2 Fig. 7 .
IMPORTANT: container emptying must always be done with the motor shut off. Wear gloves and
possibly a face mask to protect the airways from dust (always present in this operation).
FLAP-LIFT PEDAL:
By pressing the flap-lift pedal Part. 1 Fig. 9, the front seal Part. 2 Fig. 9 lifts up for picking up a large objects.
Suitable for collecting leaves, cigarette packets, etc.
BRAKE PEDAL:
By pressing this pedal Part. 1 Fig. 10, the machine slows down and stops (until the pedal is released).
PARKING BRAKE:
To leave the machine in parking position, proceed as follows: press the brake pedal with the left foot and then
insert the stop tooth with the right foot by pressing lever. To release the parking brake, simply press the pedal
Part. 4 Fig. 10 again .
FORWARD AND REVERSE PEDAL: (only for battery version)
Part. 3 Fig. 10. This pedal has two functions depending on the position of the operation switch Part. 1 of
switchboard: when the switch is in forward position, the machine moves forward when the pedal is pressed.
When switch is positioned in reverse, the machine reverses. For safety reasons, the reverse speed of the
machine is very low. When the switch is in central position, the machine moves neither forward not in reverse.
FORWARD AND REVERSE PEDAL: (only for internal combustion engine)
Part. 3 Fig. 10. This pedal has two functions depending on the position. By pressing the right side (with arrow
pointing UP) the machine goes forward while by pressing the left side (with arrow pointing DOWN) the machine
withdraws. For safety reasons, the reverse speed of the machine is very low.
SIDE BRUSH ENGAGEMENT LEVER: (for all models)
The engagement lever Part. 1 Fig. 10 makes it possible to lower the brush from the driving seat. Remember
that the side brush must only be used for cleaning edges, profiles and corners and that it continues to rotate
when the machine motor is rotating. To lower and then activate the side brush push forward lever Part. 1 fig.
10; to disconnect the side brush bring back the lever in the initial position by pulling it back.
ATTENTION:
NEVER TOUCH THE SIDE BRUSH WITH YOUR HANDS AND NEVER PICK UP THREADED
MATERIALS.
DESCRIPTION PF THE MANUAL CONTROLS
For Both Models
Battery Version.
30