Lavorwash SWL R 1000 ET Manual De Instrucciones página 32

moves neither forward nor in reverse.
ELECTRIC SWITCHBOARD CHECK LED:
Part. 2 This red led must be always switched on during functioning. If this led should flash at regular intervals
there could be technical problems within the machine. In this case you are adviced to immediately contact
assistance to check the motorsweeper.
FILTER BUZZER BUTTON:
Part. 3 This buzzer cleans the suction filters through a motor-vibrator Part. 2 Fig. 5; it must be pressed at
least 6 / 7 times for 8 / 10 seconds each (operation to be performed before starting work, before emptying the
bin and with the motor off); to perform this operation with motor running, close the suction by pulling the knob
Part. 1 Fig. 6.
ACOUSTIC INDICATOR BUTTON:
Part. 4 By pressing this button the acoustic indicator switches on.
BRUSHES MOTOR SWITCH:
Part. 5 By actioning this switch either central and side brushes are activated.
IGNITION KEY :
Part. 6 It activates the switchboard and in particular the movement potentiometer. It is therefore possible to
move the machine without have it working.
WORKING LIGHT SWITCH: Optional
Part. 7. It activates the adjustable working light.
CHARGE INDICATOR:
Part. 8 It indicates the charge level of batteries and it's represented by three coloured lights (red, yellow and
green); by turning on the ignition key Part. 6 they switch on in the following order: red-yellow-green; wait until
green light is on before forwarding or reversing. If red light should switch on batteries need recharging.
IT IS RECOMMENDED NOT TO WAIT UNTIL THE RED LIGHT TURNS ON TO PROCEED WITH
RECHARGING OF BATTERIES BUT TO PROCEED WITH THE OPERATION AS SOON AS YELLOW LIGHT
SWITCHES ON.
HOURCOUNTER:
Part. 9 Makes it visible the number of hours worked by the machine.
32