Important - Lavorwash SWL R 1000 ET Manual De Instrucciones

plate). Lift the motor bonnet and secure the four eyebolts or hooks in the threaded housings (the lifting hooks
collection bin Part. B FIG. 1 together with the side brushes and instruction manuals); secure all
are inside the
four straps to their respective lifting hooks Part. A Fig. 1 and with the aid of a fork lift truck or bridge crane
(suitable for weight of the machine), lift this off the pallet and rest it on the floor very slowly .
ATTENTION:
THE MACHINE CAN ONLY BE LIFTED WHEN ALL FOUR STRAPS HAVE BEEN SECURED TO
THEIR RESPECTIVE EYEBOLTS (M10 EYEBOLTS).
B) Position a sloping surface (having a load-bearing capacity suitable for the weight of the machine) close
up to the narrow side of the pallet. This must be at least 1,5 m long (so as not to damage the rubber dust seals)
and 1 m wide. Remove the pieces of wood around the wheels and release the parking brake Part. 1 Fig. 2,
pressing this so as to release the retention lever. At this point, simply push the machine onto the chute. This
operation must be performed without anyone in front of the machine and on a large flat surface.
At the end of the unpacking operation, remove and keep the eyebolts and fit the right side brush Part. 7 Fig. 2
and, If necessary, the left side brush as shown in page 13 .
IMPORTANT: All the materials remaining after the unpacking operation must be carefully disposed
ATTENTION:
MAKE SURE THAT THE MACHINE PROTECTION DEVICES ARE IN GOOD CONDITION AND
PROPERLY FITTED. IN THE EVENT OF FAULTS OR MISSING PARTS, DO NOT START UP
THE MACHINE AND NOTIFY THE DEALER OR MANUFACTURER
of by the user, following applicable regulations.
26