ULTIMATE SPEED ULGD 10 A1 Traducción Del Manual De Funcionamiento Original página 94

If the 24 V battery is deeply dis-
charger (below 15.6 Volt), then the
charger recognises the battery as a
12 V battery. In this case, the
program selector button
pressed seven times, to select
program 7.
The and
24V
2
are shown on the LC display. During
the charging process, the charging
display flashes. The progress of
9
the charging process (1-4 bars) will
be shown on the status display
When the battery is fully charged,
the status display shows
The flashing stops and the device
switches to trickle charging automat-
ically. The display will show "FUL".
Program 8
24V
2
(29.4 V / 5.0 A)
To charge 24 V batteries with a
capacity of 40 Ah to 100 Ah under
cold conditions or to charge AGM
batteries.
To maintain the charge of 24 V
batteries up to 150 Ah.
Press the program selector button
four times to select Program 8.
If the 24 V battery is deeply dis-
charger (below 15.6 Volt), then the
charger recognises the battery as a
12 V battery. In this case, the
must be
8
symbols
5
2
.
10
4 bars.
10
8
program selector button
be pressed eight times, to select
program 8.
The ,
24V
2
2
symbols are shown on the LC
display. During the charging pro-
cess, the charging display
flashes. The progress of the charg-
ing process (1-4 bars) will be shown
on the status display
battery is fully charged, the status
display shows
10
ing stops and the device switches
to trickle charging automatically.
The display will show "FUL".
Program 9
12V
(13.6 V / 3.0 A)
Supply program 13.6 V / 3 A max.
Press the program selector button
nine times to select Program 9.
The and
12V
3
shown on the LC display.
For use as a 12 V voltage supply
or for buffer maintenance charg-
ing, where 100% battery power is
necessary. Das supply program will
work without a time limit.
Please contact the vehicle manu-
facturer and read the operating
Using the device
must
8
and
5 6
9
. When the
10
4 bars. The flash-
symbols are
7
GB/MT 93
8