Stihl FC-MM Manual De Instrucciones página 6

!
Warning!
Edger noise may damage
your hearing. Wear sound
barriers (ear plugs or ear
mufflers) to protect your
hearing. Continual and
regular users should have
their hearing checked regularly.
Protect your hands with
gloves when handling the
power tool and the cutting
attachment. Heavy-duty,
nonslip gloves improve
your grip and protect your
hands.
Clothing must be sturdy
and snug-fitting, but allow
complete freedom of
movement.
Avoid loose-fitting jackets,
scarves, neckties, jewelry,
flared or cuffed pants,
unconfined long hair or
anything that could
become caught on
branches, brush or moving parts of the
unit.
FC-MM
Wear long pants made of heavy material
to protect your legs. Do not wear shorts,
pants, sandals or go bare foot. Secure
hair so it is above shoulder level.
Good footing is most
important in edger work.
Wear sturdy boots with
nonslip soles. Steel-toed
safety boots are
recommended.
Wear an approved safety
hard hat to reduce the risk
of injury to your head
when there is a danger of
head injuries.
THE EDGER MULTITOOL
For illustrations and definitions of the
edger MultiTool parts see the chapter on
"Main Parts".
!
Warning!
Never modify a MultiTool in any way.
Only attachments supplied by STIHL or
expressly approved by STIHL for use
with the specific STIHL power tool
models are authorized. Although certain
unauthorized attachments may be
useable on the STIHL power tool, their
use may, in fact, be extremely
dangerous.
English / USA
THE USE OF THE EDGER
Transporting the edger
!
Warning!
Always turn off the engine and make
sure the rotating attachment has
stopped before putting an edger down.
When transporting your edger in a
vehicle, properly secure it to prevent
turnover, fuel spillage and damage to the
edger.
Preparations before using the power
tool
Before starting work, set the handlebar
to the normal working position and
tighten it down firmly with the rotary
knob. See chapter on "Adjusting the
Handlebar" in the MultiEngine
instruction manual.
Always check your edger for proper
condition and operation before starting,
particularly the throttle trigger, throttle
trigger interlock (and if applicable stop
switch, cutting tool and deflector).
The throttle trigger must move freely and
always spring back in the idle position.
The cutting tool must be properly
tightened and in safe operating
condition. Inspect for loose parts (nuts,
screws, etc.) and for cracked, bent,
warped or damaged parts.
5