Stihl FC-MM Manual De Instrucciones página 8

1
3
Correct Position of Gearbox:
(using the etcher)
The gearbox output shaft (1) must be
below the drive tube (2) – the arrow (3)
shows the correct direction of rotation of
the MultiTool.
See chapter on "Mounting the
MultiTool".
Check the owner´s manual for the
MultiTool to ensure you are using the
appropriate deflector for that MultiTool.
FC-MM
Starting the engine
2
Details on starting the engine can be
found in the appropriate chapter of the
owner's manual for the MultiEngine.
Place the unit on firm ground in an open
area. The attachments must be clear of
the ground and all other obstructions.
!
Warning!
When starting, make sure you have a
firm footing - as shown; always stand to
one side of the machine to avoid risk of
injury from contact with rotating tool.
English / USA
!
Warning!
To reduce the risk of injury
from loss of control, be
absolutely sure that the
cutting tool can turn freely
when the engine is
started. When the engine
is started in the START position, engine
speed will be fast enough for the clutch
to engage and turn the cutting tool.
Working Conditions
Start and operate your power tool only
outdoors in a ventilated area.
Operate the edger under good visibility
and daylight conditions only. Work
carefully.
!
Warning!
Your edger produces toxic
exhaust fumes as soon as
the engine is running.
These gases (e.g. carbon
monoxide) may be
colorless and odorless. To
reduce the risk of serious or fatal injury
from inhaling toxic fumes, never run the
edger indoors or in poorly ventilated
locations.
7